This is default featured slide 1 title
This is default featured slide 2 title
This is default featured slide 3 title
This is default featured slide 4 title
This is default featured slide 5 title
 

Start Car With Weak Battery

If our car battery is older than 18 months then its capacity for recharging and in turn providing adequate power supply to the self-starter to start the car, is considerably reduced. In such cases, the automobile workshops advise us to replace the battery with new ones. Yet, during the intervening periods, we need to know the ways to start the car.

We face similar problem when we keep our car unused for prolonged periods and the battery is discharged on its own.

1. Push Start:

There are two ways to start a car with a weak battery. The first one is our age-old system of ‘Push Start’. The user’s guide provided by the car-manufacturers along with the vehicles do not recommend this way of starting the car. Yet, we have to resort to this way if the car stops in a remote place where there is no other way to move vehicle and reach out for a safer place.

First, make adequate arrangements for moving the car manually. Here are the ways to move the car manually for ‘push start’. Place your car on a down gradient and let the car roll down for picking-up adequate speed for moving it in 2nd gear. The other way is to take help of someone to push the car from the rear for achieving a desired speed.

Now, before moving the car you need to occupy driver’s seat and take the following actions in proper sequence:

Move the gear lever to ‘2nd gear’; press the clutch paddle full; press the accelerator a little; insert the ignition key and twist it to ‘switch-on’ position; Now ask someone to push the car as described in the proceeding paragraph. Wait for the car to achieve the desired speed. Then release the clutch until the engine starts. Your car engine will start running.

Push the clutch again and bring the gear lever to ‘neutral gear’. Now either you run the engine in idle condition or else drive away to your destination.

2. Jump Start:

The recommended way to start a car is by ‘jump start’ system. For this you need to have a well-charged battery or else you may use any other battery fitted on a car. Now you need to have a pair of two-meter long thick electric cables strong enough to withstand 30amp load. There should be crocodile clips properly attached to both the ends of the cables. Patented ready-made ‘Jump Start’ cables are also available in the market and it is advisable to have one pair of cables in our car for crisis management.

The ‘Jump Start’ procedure is simple. Bring the other car near to your car; connect the red cable to the Positive Ports (marked +) of batteries of both the cars; connect the black cable to Negative Ports (marked -) of both the batteries. By doing this you have connected the well-charged battery of the other car to your car. In other words, you are now using the battery of the other car for your own car.

Now occupy the driver’s seat; bring the gear lever to ‘neutral gear’; push clutch paddle full; insert ignition key in its slot and start your car as usual. For keeping the engine running apply hand break; let the car be in ‘neutral gear’; let the ignition key remain in its slot; open the window glass of driver’s door and come out of your car leaving the engine in ‘idle running’.

Remove the cables and keep them in your trunk. Shift the other car to its original place. Now you should drive away for recharging your car battery. Go for a long drive at least for 5 – 10 km possibly at lower gears and essentially without putting-on your AC.

In this way your battery will be recharged for your normal use. In some types of batteries, you need to check the acid-level in the battery. If the level has gone down you may pour some distilled water by opening the caps with the help of a coin.